Shorting Probes

Description

Shorting probes are used to short-circuit the probe support or the probe cable. This is done in order to cancel the influence of the cable and support resistances, when probe resistance is measured in connection with the setup of the anemometer bridge.

Configurations

Three versions are available for single, dual and triple probe supports, respectively. In addition a BNC shorting probe is available for direct short-circuiting of the probe cable.

Shorting probe for single-sensor probes

image of Shorting Probe, single sensor

This shorting probe is used for short-circuiting the 4 mm dia. supports in connection with measurements with single-sensor probes.

Buy at Dantec Dynamics’ Shop

Short-circuit resistance: R < 0.01 W

Shorting probe for dual-sensor probes

image of Shorting Probe, dual sensor

This shorting probe is used for short-circuiting the 6 mm dia. supports in connection with measurements with dual-sensor probes. It contains two separate shorting loops.

Buy at Dantec Dynamics’ Shop

Short-circuit resistance: R < 0.01 W

Shorting probe, BNC

image of Shorting Probe, BNC film probes

This shorting probe is used for short-circuiting probe cables in connection with measurements with cable-equipped probes. It is constructed as a modified BNC plug.

Buy at Dantec Dynamics’ Shop

Short-circuit resistance: R < 0.01 W

Shorting probe for triple-sensor probes

image of Shorting Probe, triple sensor probe

This shorting probe is used for short-circuiting the triple-sensor probe support.

Buy at Dantec Dynamics’ Shop

Short-circuit resistance: R < 0.01 W

More Information

Please contact your local representative or complete the dialogue form.